Impex MD-860, Owner'S Manual

STEP 3 

(See Diagram 3) 

A.)  Attach two Incline Support Frames (#15) to the Main Seat Support (#6) from both sides. 

Align the holes. Secure the Incline Support Frames to the Main Seat Support with three M10 
x 3 ½” Allen Bolts (#38), six Ø ¾” Washers (#43), and three M10 Aircraft Nuts (#46). 

B.)  Attach the Incline Support (#11) to the side-holes on the two Backrest Supports (#9). Align 

the holes. Secure it with one M10 x 6 1/8” Allen Bolt (#36), two Ø ¾” Washers (#43), and 
one M10 Aircraft Nut (#46). Place the other end of Incline Support to the selected slot on 
Incline Support Frame to hold the desired Backrest Incline. 

C.)  Attach the holes on the end of the Backrest Supports to the pivot on the Main Seat Support. 

Align the holes. Secure the two Backrest Supports to the pivot with one M12 x 6 1/8” Hex 
Bolt (#34), two Ø 1” Washers (#42), and one M12 Aircraft Nut (#45). 

D.) 

Do not over tighten the Nuts and Bolts. Make sure the Backrest Supports and Incline 
Support are able to swivel.

DIAGRAM 3