STEP 5 (SEE DIAGRAM 5)
A.) Attach the Leg Developer (#9) to the Leg Developer Holder (#5). Secure it with one M10 x
2 7/8” Allen Bolt (#36), two Ø ¾” Washers (#44), and one M10 Aircraft Nut (#47). Do not
over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert one Foam Tube (#13) halfway through the holes on the Leg Developer Holder.
Insert two Foam Tubes halfway through the holes on the Leg Developer. Push six Foam
Rolls (#20) onto the Tubes from both ends.
C.) Attach a Spring Clip (#25) to the weight post on Leg Developer.
DIAGRAM 5
10
