STEP 7
(SEE DIAGRAM 7)
A.) Insert Leg Developer Holder (#9) into the top opening on the Main Seat Support
(#1). Insert a Lock Knob (#36) into selected hole to obtain desired height.
B.) Insert an Axle (#16) into the pivot on the Leg Developer (#4). Attach Leg Developer
(#4) onto the bracket on the Leg Developer Holder (#9). Secure it with two M10 x
¾” Allen Bolts (#43) and
∅
7/8” Washers (#48).
C.) Slide one Foam Roll Tube (#15) halfway through the top hole on the Leg Developer
Holder (#9). Then slide two Foam Roll Tubes (#15) halfway through holes on the
Leg Developer (#4). Push six Foam Rolls onto three tubes. Plug the ends with six
Foam Roll End Caps (#31).
D.) Slide an Olympic Sleeve (#5) onto the weight holder on the Leg Developer (#4).
Place a Spring Clip (#19) onto the Olympic Sleeve (#5).
E.) Insert Lock Pin (#52) into the hole on the bracket on the Leg Developer Holder (#4)
to lock the Leg Developer in place. Remove the Pin when using the Leg Developer.
DIAGRAM 7
10
