Always work in a clockwise or right to left direction
when assembling.
Without support
section will collapse
No previous section,
no support
Additional foot
Supported by
previous section
5
150
2°
21mm - 30mm
42
72
47
52
57
62
67
A
B
C
Sub floor
Wall
Row 1
Row 2
Row 3
Row 4
Row 5
Row 6
Diagram 5.
A
B
C
Section 3: General Installation guidance
for all configuration types
This section is an introduction to the basic installation and assembly rules for Aqua-grade Linear.
It is important that you have read and understand these requirements before commencing installation.
Page 4
The blue corner section must always have 2 feet fitted.
When using configurations that start from a wall it is
important that 2 feet are fitted to the first section to
support the section properly.
(excludes SCR15L and SCR15R parts)
All parts have gradient slope built in,
you do not need to
adjust the feet to add gradient only to adjust height.
Using these dimension it is possible to calculate the
overall approximate finished depth required to install.
As more rows are added the adjustable feet will need to have spacers added to ensure correct gradient and levels are
maintained. The general rule is to add 1 spacer to each foot for every 2 rows that are added. (see above).
Extra spacers are supplied to help with subfloors that are very uneven or not level.
SUBFLOOR
SUBFLOOR
WALL
WALL
