Power-on Self-test
The Power-on Self-test tests the RAM and Flash Checksums.
If any parameter in the Module Self-test fails, the connected Readers will emit a
continuous beep for 2 seconds before the 2 short start-up beeps.
When the Terminal passes the Self-test, any Readers attached will emits two short
beeps, each 200 ms in duration, separated by a 200 ms inter-beep pause.
WRM Address Information
Each Impro (WRM) Wiegand Reader Module is, in fact, two Reader Interfaces in one.
The first Fixed Address is associated with Reader [1], and the second with Reader [2].
Each WRM is allocated two unique Fixed Addresses at the factory. These addresses
are stored in the WRM’s memory.
NOTE: If set to MDR mode (all dip switches off) and no MDR is connected to one
channel, the fixed address for the un-used channel will be hidden. In all
other instances both addresses on the WRM are always shown.
Fixed Address Label
Once the Impro WRM is installed, sketch a rough site plan. Attach the loose (additional
Fixed Address Label packaged with the WRM) Fixed Address Label in the position of
the Terminal on the sketched site plan. When the system installation is complete and
all the units are represented on the site plan by their Fixed Address Labels, file the site
plan for future reference.
GUARANTEE OR WARRANTY
CAUTION: We reserve the right to nullify the product’s guarantee or warranty
where you have not properly installed the Metal-oxide Varistors.
This product conforms to our Guarantee or Warranty details placed on our Web Site, to
read further please go to
www.impro.net
.
USER NOTES
HMW300-0-0-GB-00
October 2013
Page 17
