5
Visit www.improvedracing.com for additional support
6. Underneath the car, use a 10 mm tool to remove the two screws which
hold the bumper cover to the chassis, circled in
green
on Figure 2.
7. Use a T20 tool to remove all screws underneath the bumper cover, im-
mediately in front of the wheels, circled in
green
on Figure 3. There are
four per side.
8. Use a 7 mm tool to remove the screws in the wheel wells that attach to
the bumper cover, circled in
green
on Figure 4.
Tip:
Take the wheels off to make this easier, or turn them side-to-side.
Figure 2 - Removing the Bottom Bumper Cover Screws
Figure 3 - Removing the T20 Torx Screws
Figure 1 - Removing the Pop-Clips and Screws
