Visit www.improvedracing.com for additional support
7
installing env-131
1. Ensure that the O-ring is properly seated in the top of ENV-131 as shown
in Figure 1.
2. Lubricate the O-ring with oil.
3. Using a 1
1
/
4
”
socket, secure ENV-131 to the oil filter threads on the
engine block or oil pan using the included filter screw (HSC-104X).
4. Torque HSC-104X to 20 lb-ft (27 N-m).
5. Lubricate the sandwich plate fitting flares with oil and connect the oil
lines.
6. Torque both fitting connections on ENV-131 to 25 lb-ft (34 N-m).
Use aluminum tools to avoid damage to fittings.
COMPleting the installatiOn
1. Fill a new oil filter with oil and install the filter onto the sandwich plate.
Lubricate the oil filter seal with engine oil prior to installation.
2. Check the engine oil level and add oil if needed.
3. Remove the fuel pump fuse(s) or disconnect the ignition circuit.
Consult the vehicle’s factory owners manual for the fuse location.
4. Crank the engine over to build oil pressure.
5. Replace any fuse(s) removed and/or reconnect the ignition circuit.
6. Start the vehicle and inspect for leaks.
7. Turn-off the vehicle and inspect the engine oil level. Add oil if necessary.
8. Reinstall any underbody panels and safely lower the vehicle back onto
the ground.
9. Re-inspect the oil lines and fittings for leaks after 100 miles of driving.
Installation is now complete. Thank you for purchasing an Improved Racing
product!
