4
POWER FAILURE
IF THERE IS A POWER FAILURE TRY TO MINIMIZE THE NUMBER OF TIMES THE DOOR IS
OPENED.THIS WILL HELP THE MACHINE MAINTAIN A COOLER TEMPERATURE TO PRESERVE
THE ICE UNTIL THE POWER IS RETURNED. IF THE POWER IS GOING TO BE OFF FOR AN
EXTENDED PERIOD OF TIME, YOU SHOULD TAKE PRECAUTIONARY STEPS TO ENSURE
WATER FROM THE DEFROSTING DOES NOT LEAK OUT.
VACATION TIME/STORAGE
1.
SHUT OFF THE WATER SUPPLY AT THE MAIN WATER VALVE.
2.
DISCONNECT THE WATER SUPPLY LINE FROM THE VALVE.
3.
ALLOW THE UNIT TO RUN FOR AN HOUR OR TWO UNTIL ALL REMAINING ICE CUBES
HAVE BEEN EJECTED AND ALL WATER HAS CYCLED THROUGH THE SYSTEM AND HAS
BEEN MADE INTO ICE CUBES.
4.
DISCONNECT THE UNIT FROM THE MAIN POWER SOURCE.
5.
DRY OUT EXCESS WATER FROM THE ICE MAKER ASSEMBLY
6.
LEAVE THE DOOR OPEN AT LEAST TWO INCHES.
MOVING YOUR ICE MAKER
SECURELY TAPE DOWN ALL LOOSE ITEMS INSIDE YOUR ICE MAKER.
TURN THE LEVELING SCREWS UP TO THE BASE TO AVOID DAMAGE.
TAPE THE DOOR SHUT.
MAKE SURE THE ICE MAKER STAYS IN THE UPRIGHT POSITION DURING
TRANSPORTATION.
ENERGY SAVING TIPS
THE ICE MAKER SHOULD BE LOCATED IN THE COOLEST AREA OF THE ROOM, AWAY
FROM HEAT SOURCES, AND OUT OF THE DIRECT SUNLIGHT.
ICE CUBE QUANTITY AND CYCLE TIME:
PLEASE USE THE INFORMATION BELOW TO DETERMINE THE CYCLE TIMES FOR YOUR ICE
MAKER PRIOR TO CALLING CUSTOMER SERVICE.
Your ice maker will make the first batch of ice in approx. 2-hours from the time you first
turn in on. It will start consistently making ice every 40~50 minutes after first batch. The
water pump delay is to allow the machine to reach a low enough temperature to maintain
ice structure.
ICE CUBE QTY
WATER
PUMP
DELAY
FIRST BATCH CYCLE
TIME
NORMAL
CYCLE TIME
ICE CUBE
SIZE
IM-150US
8
20-30 min
50-60 min
40-50 min
large
