15
S t e p 1 0
Ro u t e T h e C a b l e s
1)Put the clip tied on the weight pin leash onto the Top
Plate(#41) as shown, next connect the Cable(#44) to
the Top Plate(#41).
2)Route the Cable(#41) up and over the two Pulleies A
(#69).then secure them to the Main Upright(#1) using
3)Insert the Cable(#44) through the Main Upright(#1),
next route it over the Pulley B(#69),then secure them
to the Main Upright(#1) using:
4)Connect the looped end of the Cable(#44) to the Cam
(#7),secure it using one Screw(#54) as shown below.
5)Connect the Assistant Cable(#45) to the "L" Cam(#5)
using:
6)Route the Assistant Cable(#45) up and over the Pulley
C(#69),and secure them to the Main Upright(#1) using
7)Route the Assistant Cable(#45) down and under the
Pulley D(#69), and secure them to the Main Upright
(#1) using:
8)Route the Assistant Cable(#45) around the Pulley E
(#69),and secure them to the Seat Support(#3) using
9)Connect the Assistant Cable(#45) to the Start Up Foot
Frame(#10) using:
10)Adjust the tension of the Cable (#44) using the Jam
Nut as shown.
11)Make sure that the cables are in grooves of all pull-
eies then fully tighten all bolts and nuts .
12)Select an approprate weight with the weight pin.
two Allen Bolts(#51) M10×45
four Washers(#61)
11× 20×1.5
two Nylon Locknuts(#63) M10
one Shoulder Bolt(#57)
M10×50
two Half-pulley Covers(#67)
one Nylon Locknut(#63)
M10
one Shoulder Bolt(#78) M8×35
one Nylon Locknut(#79) M8
one Allen Bolt(#51) M10×45
two Washers(#61)
11× 20×1.5
one Nylon Locknut(#63) M10
one Shoulder Bolt(#57) M10×50
two Pulley Covers(#66)
one Nylon Locknut(#63) M10
one Allen Bolt(#55) M10×60
two Pulley Covers(#66)
one Nylon Locknut(#63) M10
one Shoulder Bolt(#78) M8×35
one Nylon Locknut(#79) M8
Φ
Φ
Φ
Φ
