12/89:
PARTS-5
INTRODUCTION
GENERAL
This manual contains the parts drawings with
accompanying parts lists for the assemblies used on
this crane. These drawings are intended to be used in
conjunction with the instructions found in the
Instruction Manual.
WARNING
DO NOT ATTEMPT TO REPAIR ANY
COMPONENT WITHOUT READING THE
INFORMATION CONTAINED IN THE
INSTRUCTION MANUAL. PAY PARTICULAR
ATTENTION TO THE WARNINGS, CAUTIONS
AND NOTES CONTAINED IN THAT MANUAL.
FAILURE TO COMPLY WITH THESE
INSTRUCTIONS MAY RESULT IN DAMAGE TO
THE EQUIPMENT, AN INJURY OR EVEN
DEATH.
CRANE IDENTIFICATION
Every crane has a serial number placard attached to
the mast or base. When ordering parts,
communicating warranty information or referring to the
unit in correspondence, always include the assigned
serial number and model number as shown on the
serial number placard.
ORDERING REPAIR PARTS
When ordering replacement parts:
1. Give the model number of the unit.
2. Give the serial number of the unit.
3. Specify the complete part number. When ordering
complete cylinders or assemblies, identify the
cylinder or assembly by name.
4. Give a complete description of the part.
5. Specify the quantity required.
All inquiries should be addressed to:
Iowa Mold Tooling Co., Inc.
Box 189, Garner, IA 50438-0189
Telephone: 641-923-3711
Technical Support Fax: 641-923-2424
SERIAL NUMBER PLACARD
99903049:20111201
1. Suspension traverse
2. Control valve block
3. Stabilizer beam
4. Stabilizer leg
5. Tank
6. Rotation/Slewing cylinder
7. Base
8. Boom cylinder
9. Mast
10. Link arm
11. Hinge pin
12. Main boom
13. Outer/jib cylinder
14. Outer/jib pin
15. Outer boom
16. Extensions
17. Extension cylinder
COMPONENT REFERENCE
MODEL
NUMBER
SERIAL
NUMBER
MFG
DATE
IOWA MOLD TOOLING CO., INC.
BOX 189, GARNER, IA 50438-0189
700291
19
Summary of Contents for 12/89
Page 91: ...12 89 PARTS 91...
