46
IMT CAS3560 Air Compressor Manual Part No. 99903566
NOTE
When connecting drain line, hold canister nut securely when tightening the hose fitting.
WARNING
Do not substitute element. Use only a genuine IMT replacement element. This element is
rated at 200 psi working pressure. Use of any other element may be hazardous and could
impair the performance and reliability of the compressor, possibly voiding the warranty and/or
resulting in damage to property and serious bodily harm.
OIL FILTER
The compressor oil filter is a spin-on, throw away type. After replacing filter, dispose of used
filter according to local and state hazardous waste regulations.
To replace filter:
1
Make sure system pressure is relieved.
2
Remove filter by unscrewing from filter head (turn counterclockwise by hand) and discard.
3
Install a new filter by applying a little oil to the seal and then screw the filter on by hand
(turning it clockwise until hand tight, plus one - third turn). Do not use tools to tighten the
filter.
4
Check for leaks in operation.
5
Re-check compressor oil level.
WARNING
Do not substitute element. Use only a genuine IMT replacement element. This element is
rated at 200 psi working pressure. Use of any other element may be hazardous and could
impair the performance and reliability of the compressor, possibly voiding the warranty and/or
resulting in damage to property and serious bodily harm.
OIL COOLER
The interior of the oil cooler should be cleaned when the pressure drop across it at full flow
exceeds 25 PSI.
The following procedure has been recommended by the vendor who supplies the cooler:
1
Remove cooler.
2
Circulate a suitable solvent to dissolve and remove varnish and sludge.
3
Flush generously with IMT compressor lubricant.
4
After cooler is reinstalled and compressor is filled with fresh oil, change compressor oil afer
50 hours of normal operation.
