99906549 rev 00 (JANUARY-2020)
1 - 3
SECTION 1: SAFETY
IOWA MOLD TOOLING CO., INC.
(641) 923-3711
CAS40PL, CAS40PL-CW, CAS40PLE, CAS40PLE-CW
tions are replaced before applying power to
the compressor.
• Avoid touching hot surfaces and components.
• Ensure that electrical wiring, terminals; hoses
and
fi
ttings are kept in serviceable condition
through routine inspections and maintenance.
Replace any damaged or worn components.
1.3.4
NOTES
NOTE
Additional information (or existing information)
which should be brought to the attention of op-
erators/maintainers a
ff
ecting operation, mainte-
nance, or warranty requirements.
Note boxes are usually listed to convey and give
focus to a distinct piece of information, which is
not directly related to a safety issue, but is nec-
essary to understand machine function and op-
eration. Special note referrals in the manual may
be contained in a box titled with an IMPORTANT
banner, as shown below, and may also contain
the WARNING symbol, should the information be
linked to a safety issue:
IMPORTANT
Additional, CRUCIAL information (or existing
information) which should be brought to the
attention of operators/maintainers a
ff
ecting op-
eration, maintenance, or warranty requirements.
1.4
SAFETY DECALS
Safety decals are placed onto, or located near,
system components that can present a hazard to
operators or service personnel. All pertinent de-
cals listed in
Section 7.12, Decal Identi
fi
cation/
Locations
, are located near a component which
is subject to respect in terms of safety precau-
tions. Always heed the information noted on the
safety decals.
WARNING
DO NOT REMOVE OR COVER ANY SAFETY
DECAL. Replace any safety decal that becomes
damaged or illegible.
1.5
DISPOSING OF MACHINE
FLUIDS
Always dispose of machine
fl
uids under the guid-
ance of all applicable local, regional and/or fed-
eral law.
IMT
®
encourages recycling when allowed. For
additional information, consult the container label
of the
fl
uid in question.
Summary of Contents for CAS40PL
Page 2: ...BLANK PAGE...
Page 81: ...BLANK PAGE...
