SECTION 3:
INSTALLATION
99906549 rev 00 (JANUARY-2020)
3 - 1
SECTION 3: INSTALLATION
IOWA MOLD TOOLING CO., INC.
(641) 923-3711
CAS40PL, CAS40PL-CW, CAS40PLE, CAS40PLE-CW
3.1 MACHINE
PACKAGE
RECEIPT/INSPECTION
Upon receipt of the machine package, inspect the
exterior of the shipping crate for signs of shipping/
transit damage. Any damage should be reported
immediately to the shipping company.
NOTE
Before fully unpacking the unit, inspect the
component parts, supports and loose-packed
parts to ensure that there have been no inter-
nal movements of assemblies or components,
which may have been damaged during ship-
ment.
Should any damage be discovered during pack-
age inspection, contact the shipping company
immediately.
Iowa Mold Tooling Co., Inc.
500 Highway 18 West
Garner, Iowa 50438
Phone: 641.923.3711
Fax: 641.923.2424
www.imt.com
3.2 GENERAL
INSTRUCTIONS
This section provides general guidance for lo-
cating and preparing the CAS40PL compressor
package for operation. Each installation is unique
and can be a
ff
ected by location, ventilation, and
other factors such as electrical and hydraulic
power supply availability and location.
DISCLAIMER
DO NOT install in any enclosed space without
fi
rst contacting IMT.
WARNING
Install, operate, and maintain this equipment in
full compliance with all applicable OSHA, other
Federal, state, local codes, standards, and regu-
lations.
WARNING
Before performing maintenance or repair oper-
ations on the compressor, ensure that all power
has been removed and locked out to prevent
accidental start-up.
DO NOT assume that because the compressor
is in a STOPPED condition that power has been
removed.
WARNING
DO NOT perform any modi
fi
cations to this
equipment without prior factory approval.
WARNING
DO NOT use plastic pipe, or incorrectly rated
piping or hose. Incorrectly rated connection
material can fail and cause injury or equipment
damage.
WARNING
DO NOT operate the compressor in enclosed or
con
fi
ned spaces where ventilation is restricted
or closed o
ff
.
NOTE
Install electrical components (circuit breakers,
pressure switches, toggle switches, etc.) in
locations where exposure to water or moisture
will be most minimized.
NOTE
In order to prevent accidental damage to vehi-
cle components (fuel tanks, lines, brake lines,
wiring harnesses), note their location before
drilling any holes.
Summary of Contents for CAS40PL
Page 2: ...BLANK PAGE...
Page 81: ...BLANK PAGE...
