99906549 rev 00 (JANUARY-2020)
4 - 3
SECTION 4: OPERATION
IOWA MOLD TOOLING CO., INC.
(641) 923-3711
CAS40PL, CAS40PL-CW, CAS40PLE, CAS40PLE-CW
6
Figure 4-2: Controller Screen Identi
fi
cation and Navigation
KEY
SCREEN
DESCRIPTION
A
INITIAL
SCREEN
PRE-SCREEN:
This automatic screen appears when the controller is
fi
rst initiated. It remains for a
few seconds, then changes to the Controller Revision Screen.
B
CONTROLLER
REVISION SCREEN
PRE-SCREEN:
This screen shows the current version of the Display and Controller software. It
remains for a few seconds, then changes to the Main Screen.
1
MAIN SCREEN
This is the default screen (Pressure Screen). It shows the current pressure status of the machine. Pressing ESC from any other screen will bring this screen up.
2
SETTING ADJUSTMENT
DISPLA
Y SCREEN
This screen shows the preset cut-in and cut-out pressures for the range of operation.
These pres-
sures can be adjusted by pressing the Up or Down arrows. Note that, when adjusting the Cut-in / Cut-out pressure, the relationship between cut- in and cut-out remains proportional.
3
CUT
-IN/CUT
-OUT
PRESSURE SCREEN
This screen allows the operator to change some of the machine functions.
This includes changing
the cut-in / cut-out pressure, and toggling the solenoid functions to either ON or OFF
.
4
SER
VICE REMINDER
SCREEN
This screen shows the support phone number to contact the IMT
Service Department.
5
SERVICE INTER
VA
L
INFORMA
TION SCREEN
This screen appears during the boot-up process. It gives the time interval left until the next service task, and identi
fi
es the task.
6
SERVICE CONT
ACT
SCREEN
This screen appears during the boot-up process. It gives a reminder that a service interval is approaching.
7
TEMPERA
TURE SCREEN
This screen shows the current (running) temperature of the machine.
Summary of Contents for CAS40PL
Page 2: ...BLANK PAGE...
Page 81: ...BLANK PAGE...
