SECTION 6:
TROUBLESHOOTING
SECTION 6: TROUBLESHOOTING
CAS40PL, CAS40PL-CW, CAS40PLE, CAS40PLE-CW
99906549 rev 00 (JANUARY-2020)
6 - 1
IOWA MOLD TOOLING CO., INC.
(641) 923-3711
6.1 GENERAL
INFORMATION
This troubleshooting guide has been compiled
from operational and test data. It lists malfunc-
tions/fault conditions, possible causes, and sug-
gested corrective actions for the most common
types of problems that may occur. However,
DO
NOT
assume that these are the only problems
that may occur. All available data concerning the
trouble should be systematically analyzed be-
fore undertaking any repairs or component re-
placement procedures. While it is intended to be
comprehensive, operators and maintainers can
encounter malfunctions or problems not listed in
this table.
A detailed visual inspection is worth performing
for almost all problems, and may avoid unnec-
essary additional damage to the machine. The
procedures which can be performed in the least
amount of time and with the least amount of re-
moval or disassembly of parts, should be per-
formed
fi
rst. Always remember to:
1. Check for loose wiring.
2. Check for damaged piping.
3. Check for parts damaged by heat or an elec-
trical short circuit, usually noticeable by dis-
coloration or a burnt odor.
Should the problem persist after making the rec-
ommended check, consult your nearest IMT
®
rep-
resentative or the IMT, Inc. Service Department.
WARNING
Install, operate, and maintain this equipment in
full compliance with all applicable OSHA, other
Federal, state, local codes, standards, and
regulations.
WARNING
Before performing maintenance:
Shut down machine, relieve all system pres-
sure and lock out all power, as per the Safety
Section of this manual.
NOTE THAT THE SYSTEM CAN BE STARTED
REMOTELY:
Always clearly tag the start-up instrumentation
against accidental system start-ups during
maintenance.
Iowa Mold Tooling Co., Inc.
500 Highway 18 West
Garner, Iowa 50438
Phone: 641.923.3711
Fax: 641.923.2424
www.imt.com
Figure 6-1: Machine Serial Plate Location
Summary of Contents for CAS40PL
Page 2: ...BLANK PAGE...
Page 81: ...BLANK PAGE...
