User Manual
ILED Aquarius Floodlight
901.043.02 User Manual ILED Aquarius Floodlight
3
Version 2.1 201603
1.
Safety
To ensure that the product is used safely and to optimize its useful life, the following instructions must be
observed.
Only qualified personnel may install the product.
Observe the locally applicable safety standards and safety regulations.
During assembling, make sure the light fitting is not subjected to mechanical stress, mount on a flat
surface.
Use all the mounting holes when installing the light fitting.
Ensure that the cable gland used is suitable for the dimensions and type of cable to be connected.
This is necessary, otherwise the IP protection cannot be guaranteed.
Ensure that the cable gland used has an IP level of IP66, IP67 or IP68 in conformance with EN 60529,
and in case of an explosion proof lighting fixture, is Ex-e certified according to IEC 60079-7.
Ensure there is a reliable connection to the earthing system, both with the external earthing point and
with the connection in the light fitting junction box.
Never open the light fitting's housing.
Do not clean the light fitting using pressurized steam or a high-pressure water jet, to avoid damage not
covered by the warranty.
2.
Warranty
2.1
General
The warranty for the ILED Aquarius Floodlight light fittings is only valid when the light fitting is used within the
operating limits. The operating limits are:
The minimum and maximum ambient temperature for the ILED Aquarius Floodlight light fitting is -40°
C and +55°C
The light fitting must be installed by qualified personnel according to the installation instructions.
Damage caused by incorrect installation, accidents or external influences, such as a lightning strike or
harmonic distortion that are not within EN 50055, are not covered by the guarantee.
The light fitting's lighting level depends on the temperature and is, therefore, not covered by the warranty.
If an ILED Aquarius Floodlight light fitting fails within the warranty period, IMT B.V. will provide a new light fitting
with similar specifications free of charge. Before it can be confirmed that the damage is covered by the warranty,
the defective light fitting must be sent to IMT B.V. at the user’s expense for inspection. The user will be informed
of the result(s) of the inspection. For individual warranty agreements see invoice.
