IN & OUT HOUSE EF197A Manual Download

Page: 19 / 80

The communication frequency between the unit and the remote control has
already been preset. If you cannot use the remote control with the unit, follow
the instructions “Set up communication between the remote control and the
unit” to re-establish the connection.

REMOTE CONTROL’S STANDBY MODE

The screen shows the remote control’s standby mode.

SWITCH ON/OFF

Press this button to switch the flame effect and the heater on or off. Press
this

button to switch the flame effect on or off in daily or weekly timer mode.

FL AME EFFECT

Press to display the screen for adjusting the flame effect. Press the and

button to select the three-level flame effect. Press the ‘+’ and ‘-’ buttons to

select the five levels of flame effect brightness and the OFF setting.

MOOD LIGHT

Press

to display the screen for adjusting the mood lighting. Press the

and

button to toggle through the 13 colours of the mood light or a colour

cycle mode. Press the ‘+’ and ‘-’ button to select the five brightness levels of
the mood light.

BASE TR AY LED LIGHT

Press the

button to access the screen for adjusting the LED light in the base

tray. Press the and button to toggle through the 13 colours of the LED light
or a colour cycle mode. Press the ‘+’ and ‘-’ button to select the five brightness
levels for the lighting.

NORMAL MODE

The normal control mode is set at the factory. If this is not the case, press the M
button until the logo is displayed in the upper corner of the screen. Press the
‘+’ and ‘-’ buttons to adjust the setting temperature from 17 °C to 25 °C in two
intervals. Press the button

to switch the heater on and off. ON and OFF are

displayed at the bottom of the screen.

NOTE: It is normal for the fan heater to stop running for some time. This
happens because the room temperature is at or above the temperature
set on the remote control. The heating indicator is switched off after
10 seconds when the flame is on. The heating indicator stays on when
you only use the heating function.

TIMER

HINWEIS: This setting only applies to normal mode. This allows the unit
to switch to standby mode after a certain period.

Press the

button to switch between the settings OFF and 0.5 hours to

9 hours. The timer logo and time are displayed on the screen. The heater must
be in the ON position. The heater can be operated automatically using the daily
timer and the weekly timer on the remote control. Set the day, time and your
desired temperature.

Press the button to activate the remote control. Press and hold the M button
for three seconds to display the settings screen. Press the and button to
select the day, time or your desired temperature. The selected function is high-
lighted. Press the ‘+’ and ‘-’ button to set the value.

•   Time: 24-hour system
•   Select your desired temperature from 15–25 °C .
•   Temperature unit: °C , °F

TIMER FOR DAILY HEATING

The following times are preset heating times that can be altered if desired.

6:00 a.m. to 8:30 a.m., 5:00 p.m. to 10 p.m.

Press the M button until

is displayed in the upper right corner of the screen

and then enter the daily heating interval. Press and hold the arrow button for
six seconds to display the daily timer settings. Maximum three heating periods
per day.

•   Press   or   to select hour or minute, press ‘+’ or ‘-’ to set the time.
•   The minute indicator will increase/decrease by 15 minutes per press.
•   Press   and hold the button for three seconds or wait 10 seconds to save

and exit the heating time setting.