NCSTS9
2
• Thank You!
It’s a good idea to read all of the instructions before beginning
the installation.
• Tools and Supplies
You will need these tools and supplies to install your NCSTS9:
• 1.0 mm flat head screwdriver
• Philips hand screw driver
• Wire cutters and strippers
• Electrical tape
• Volt meter/test light
• Crimping tool
• Fork Crimp connectors
• 18 gauge wire for power connections
• Two #6 PFH (0.14” x 0.50”) screws for mounting
• Disconnecting the Battery
To prevent a short circuit, be sure to turn off 12V power and
remove the negative (-) battery cable prior to installation.
• Selecting the Mounting Location
Select a mounting location, taking care to avoid the following:
• Places exposed to heat-radiating appliances such as electric
heaters
• Adjacent to other equipment that radiates heat
• Poorly-ventilated or dusty places
• Moist or humid locations
• INTRODUCTION
• Key Features:
• 3.2" back-lit LCD touchscreen
• Designed for NCSP3/NCSP35 iN-Command systems
• Total 9 assignable buttons for iN-Command functions
( Total three pages, 3 buttons per page)
• Momentary button for slide, awning, jack, and hitch
• Safety Passcode Lock Screen for motorized functions
• Passcode Lock Screen OFF behavior to sync with DC setting
• RV-C interface communication
• Single installation supports 8 total NCSTS9 Touch Switches
• Supports Dimmer Module
