800-446-7488
20
www.in-situ.com
Obtaining Repair Service
If you suspect your system is malfunctioning and repair is needed, you can help assure efficient servicing by following these
guidelines:
1. Call or email In-Situ Technical Support. Have the product model and serial number available.
2. Be prepared to describe the problem, including how the product was used and the conditions noted at the time of the
malfunction.
3. If Technical Support determines that service is needed, they will ask your company to fill out the RMA form and pre-approve a
specified monetary amount for repair charges. When the form and pre-approval is received, Technical Support will assign an
RMA (Return Material Authorization) number.
4. Clean the product as described in the manual.
5. If the product contains a removable battery, remove and retain it unless you are returning the system for a refund or Technical
Support states otherwise.
6. Carefully pack your product in its original shipping box, if possible.
7. Mark the RMA number clearly on the outside of the box.
8. Send the package, shipping prepaid, to:
In-Situ
ATTN: Repairs
221 East Lincoln Avenue
Fort Collins, CO 80524
The warranty does not cover damage during transit. In-Situ recommends insurance for all shipments. Warranty repairs will be
shipped back prepaid.
Outside the U.S.
Contact your international In-Situ distributor for repair and service information.
Appendix - Alarms
Alarms - Overview
The Cube monitors up to eight parameters that trigger warnings and alarms based on measurement values compared to a set of
thresholds. Each alarm must be in either Absolute Mode or Incremental Mode.
When a warning is triggered, the measurement is stored in the log memory even if the Cube is not designated to save that reading.
When an alarm is triggered, the reading is stored and an alarm message is sent (if the corresponding alarm has been enabled).
Alarm Mode is set in the Probe and Set-Point Configuration Menu, under the Parameters Monitoring tab.
