In-situ Aqua TROLL 500 pH/ORP Instruction Sheet Download

Page: 1 / 3

970-498-1500

www.in-situ.com

2020-08-13 | 0063472

Page 1

Aqua TROLL 500/600 pH/ORP Sensor Overview

The pH/ORP sensor is a combination single-junction electrode that contains a

platinum ORP sensor, glass pH sensing bulb, replaceable junction, and refillable

reference electrolyte solution.

Getting Started

Instruction Sheet

Install sensor.

Remove restrictor from

the instrument.

Install sensor. Do not

twist.

Remove sensor port plug

if installed. Do not twist.

Lubricate o-ring at

bottom of sensor.

Place restrictor on

instrument in calibration

mode.

Rinse sensor with clean

water before use.

You must have a Temperature or Conductivity/Temperature sensor installed to use the

pH/ORP sensor.

Calibrate and deploy.

For detailed calibration instructions, see the instruction manual or quick start guide for your

In-Situ instrument.

Summary of Contents for Aqua TROLL 500 pH/ORP

Page 1: ...onSheet Installsensor 1 Remove restrictor from the instrument Install sensor Do not twist Remove sensor port plug if installed Do not twist Lubricate o ring at bottom of sensor Place restrictor on ins...

Page 2: ...hten until it touches sensor body Discard old solution Insert the fill tube into the bottom of reservoir Squeeze a steady stream of solution into the reservoir while slowly pulling out the tube Replac...

Page 3: ...p Soak the sensor in 5 HCl solution for 10 to 30 minutes If deposits persist alternate soaking in 5 HCl and 5 NaOH solutions Clean the sensor with warm water and mild soap Methanol or isopropyl alcoho...