Box Contents
1. Documentation
2. Software CD
3. Aqua TROLL 500 sonde
4. Maintenance kit
5. Instrument tools
6. Sensor
7. pH/ORP or ISE sensor maintenance supplies
8. RDO cap
Getting Started
Installing the RDO Cap and pH/ORP Sensor...
1
Remove the restrictor
from the instrument.
Use included Allen
wrench to loosen set
screw on RDO sensor.
Place Allen wrench in the
small hole at the bottom
of the sensor.
Lever the Allen wrench
towards the top of the
sonde to slide the sensor
out.
Pull the plastic cap off of
the RDO sensor.
Install the RDO cap on
the sensor.
Insert RDO sensor in
instrument sensor port.
Sensor tongue must
slide into blue motor
interlock groove.
1
3
6
5
4
7
8
2
Interlock
grooves
!
Your Aqua TROLL 500 ships with all sensors installed except for pH. If your instrument does not include
a pH/ORP sensor, all four sensors will be installed by the factory.
Aqua TROLL 500 Quickstart Guide
Information subject to change without notice. In-Situ, In-Situ logo, Baro Merge, BaroTROLL, HERMIT, HydroVu™, iSitu, Pocket-Situ, RDO, RuggedCable, RuggedReader, SmarTROLL™, TROLL,
VuSitu, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.
©
2016. All rights reserved. This product may be covered by patents identified at www.in-situ.com/patents
