-
5 -
Hazardous conditions, devices and cables:
Hazardous electrical conditions usually present on power
supply units, and communication cables. Disconnect the power cord, and any other device which
attached to the server before opening the case. Otherwise, it will raise the risk of personal injury or
equipment damage.
Electrostatic discharge (ESD) and ESD protection:
In most cases, ESD damages disk drives, electronic
boards, and other parts. We recommend that you work the installation only at an ESD free space. If the
situation does not allow, perform ESD protection actions by wearing an anti-static wrist strap attached
to ground any unpainted metal surface on your server during your operation.
Installing or removing jumpers:
A jumper is a short length of conductor used to close, open or bypass
part of an electronic circuit. Jumpers on In Win backplane have a small tab on top that you can pick up
with your fingertips. Grip the jumper carefully, and plug the jumper to cover the jumper pins on the
backplane. Once you need to remove the jumper, gripping the jumper, and carefully pull out without
squeezing.
CAUTION
To avoid damage and prove your safety, please notice and following the terms listed below:
1.
No to populate hard drives and turn on the power before the system is settle down.
2.
Tighten or loosen all the screws, please use screw driver to operate.
3.
Apply the correct screws which packed in the accessories box.
4.
For your safety, it requires at least two persons lift, and place the unit.
5.
Before mounting the unit to the cabinet, make sure the rail is installed correctly.
6.
When installing and removing any module or parts, please operate by the handles.
Summary of Contents for IW-RS316-03
Page 1: ...IW RS316 03 User s Manual...
Page 4: ...3...
