7
●
This product is shipped with the reclining seat back in its fully reclined position. Be sure to raise
the seat back to its fully upright position.
●
Do not expose the chair to sudden bursts of heat. If the room where the chair is to be used is cold,
turn the heat up slowly. If the chair is moved from a cold place into a heated room, wait one hour
before using the chair.
→
Condensation could occur in the moving parts of the chair, which may compromise performance.
Installation
Allow for at least 50 cm (20 inch) clearance behind and in front of the chair when reclining so as to be able
to recline the seat back fully without obstruction.
Caution
●
Do not install the chair in an area of high humidity, such as a bathroom or sauna.
●
Install on a fl at, level surface only.
●
Do not use in areas of high debris or dust content. Do not use where the ambient temperature is 40°C (104°F) or over.
●
Do not install the chair where it can come into contact with direct heat, such as direct sunlight or a radiator.
●
Keep fi re sources such as cigarettes and ashtrays away from the chair.
●
To avoid damaging fl oor surfaces and to minimize the chair noise, it may be better to install the chair on a
carpeted surface or to lay a piece of carpet under the chair.
(Do not install on an electric carpet.)
●
The chair is heavy, so please be careful when unloading it so as not to damage fl oor surfaces.
●
Install the chair at least 1 m (39 inch) away from TVs, radios, and other audio or video equipment. Otherwise
they may make noises aff ected by the operation of the chair.
●
The load to the fl oor per 1
cm
2
(0.15 inch
2
) is approximately 2.3 kg (5.1 lb), with a person weighing 100 kg (220
lb) sitting on the chair.
BEFORE USE
50 cm
(20 inch)
[BEFORE USE]
50 cm
(20 inch)
Checking the Supplied Items
Check that the chair and the other items are all in the package.
*This product is shipped with the armrests being installed.
For removing the armrests, see page 8.
Items Included
Chair
Operating Manual
(this document)
Shiatsu Balls
ࠉࠉࠉࠉࠉ
Remote Control Pocket
ࠉࠉࠉࠉ
T-shaped Wrench
AC Cord
ࠉࠉࠉࠉࠉࠉࠉࠉࠉ
Buffer Pad
Chair
Summary of Contents for Flex 3s HCP-S373A
Page 31: ......
