ISDN Port Configuration
277
Step 4
(prt-isdn) [
slot
/
port
]#up
Activate the port.
At the end of the configuration procedure re-
enabling the port activates the configuration
changes.
Example: Shutting Dow n and Enabling an ISDN port
The following example shows how to enter the configuration mode for ISDN port 0/0, disable and
activate the port.
172.16.40.71>
enable
172.16.40.71#
configure
172.16.40.71(cfg)#
port isdn 0 0
172.16.40.71(prt-isdn)[0/0]#
down
Add here the configuration changes
172.16.40.71(prt-isdn)[0/0]#
up
28.5 Configure Common BRI and PRI Parameters
Layer 3 signaling, the ISDN UNI side and smart-disconnect are settings applicable to both BRI and
PRI ports. The several settings are described in the configuration steps below. See ’Hardware
Installation Guide’ for more information on slot and port numbering conventions.
The clock source depends on the UNI-side configuration of the ISDN ports. Table 28-1 shows what
clock-source is used in the different ISDN port configurations.
Port 0 UNI-side
Port 1 UNI-side
Clock Source
USR
USR
Port 1 used as reference
NET
NET
Internal clock generation
USR
NET
Port 0 used as reference (The only mode that the
SmartNode 1200 supports)
NET USR Not
supported
Table 28-1: Clock-Sources used for ISDN Port Configurations
Note:
On the SmartNode 1000 series the clocking of the BRI ports is not configurable through an
explicit CLI command. The SmartNode 1400 needs to be rebooted twice after changing the clock-
source.
Procedure
To configure common BRI and PRI settings
Mode
Port ISDN
Software Configuration Guide Release 2.10, Revision 1.00
Summary of Contents for SmartWare Release 2.10
Page 2: ...2 Legal Notice Software Configuration Guide Release 2 10 Revision 1 00...
Page 15: ...Terms and Definitions 15 Software Configuration Guide Release 2 10 Revision 1 00...
Page 218: ...218 PPP Configuration no shutdown Software Configuration Guide Release 2 10 Revision 1 00...
Page 272: ...272 Tone Configuration Software Configuration Guide Release 2 10 Revision 1 00...
