Inalto IBM529X, User Manual

PAGE 8

UNPACKING

Packaging materials:

•  This appliance has been packaged to protect 

it against transportation damage. Remove all 

packaging materials from around and inside 

the appliance and keep the original packaging 

carton and materials in a safe place. It will help 

prevent any damage if the product needs to be 

transported in the future, and you can use it 

to store the appliance when it is not in use. In 

the event the carton is to be disposed of, please 

recycle all packaging materials where possible. 

•  Suffocation: Plastic wrapping can be a 

suffocation hazard for babies and young 

children, so ensure all packaging materials are 

out of their reach and disposed of safely. 

•  Power cord: Unwind the power cord to its 

full length and inspect it for damage. Do not 

use the appliance if it or its cord have been 

damaged or are not working properly. In case 

of damage, contact our after sales support line 

for advice on examination, repair or return of 

the damaged product. 

•  Read the manual: Read this manual to 

familiarise yourself with the appliance. Pay 

particular attention to the safety instructions 

on the previous pages. 

•  Clean: To remove any dust from transit and 

storage, wipe the interior and exterior surfaces  

of the appliance with lukewarm water and  

a soft cloth. Dry thoroughly. 

•  Do not spray or heavily wash the appliance as it 

may affect the electrical insulation properties.

LOCATION

Precautions before installation: 

•  Before installing or adjusting the accessories 

of your unit, ensure that the refrigerator is 

disconnected from the power.

•  Take precautions to prevent damaging the unit 

or causing self harm.

•  When selecting a position for your unit you 

should make sure the floor is flat and firm, and 

the room is well ventilated. 

•  Avoid locating your unit near a heat source, e.g. 

cooker, boiler or radiator.

•  Avoid locating your unit in damp or wet 

conditions to prevent rust or performance.

•  Avoid locating your unit in direct sunlight as it 

may increase the electrical consumption. 

•  When installing the unit, ensure that 10 cm of 

free space is left at both sides, 10 cm at the rear 

and 30 cm at the top of the unit. This will allow 

cold air to circulate around the refrigerator and 

improve the efficiency of the cooling process.

Installation Instructions