USER MANUAL
PAGE 08
IMPORTANT!
You must observe the ventilation requirements shown in the drawing below.
IMPORTANT!
There are ventilation holes around the outside of the cooktop. You must ensure that these holes are
not blocked by the benchtop, when you put the cooktop into position.
► Your Inalto cooktop comes fitted with the sealing strip already attached to the underside of the cooktop. This should
not be removed as it will prevent liquid or spillages from penetrating the underside of the cooktop.
IMPORTANT!
Do not use a silicon sealant to seal the appliance against the aperture. This will make it difficult to
remove the cooktop from the aperture in the future, particularly if it needs to be serviced.
► Carefully lower the cooktop into the cut-out.
ELECTRICAL CONNECTION
IMPORTANT!
The connection of this cooktop must be carried out by a suitably qualified and licensed electrician, in
accordance with the current versions of the following:
► Gas Safety and Measurement Regulations 2010
► AS/NZS 3000 Wiring Rules
► Electricity Safety Regulations 2010
► The installation instructions within this user manual
Before connecting the cooktop, make sure that the supply voltage marked on the rating plate corresponds with that of your
mains supply voltage.
Warning!
The cooktop must be earthed.
INSTALLATION INSTRUCTIONS
