Front Right Base End Stop
Z-Axis Micros-witch Adjusting
F13
Set lower set screw protrusion (F11) to approximately 20mm and tighten
(F13) lock nut. Slowly jog Y-axis unit-ll limit switch triggers, adjust upper
hard stop set screw (F10) unitil finger tight, lock in place with (F13) nut.
F13 (x2)
F11 (x2)
E2
F11
20mm
3/4”
E3
Adjust the position of limit switches (E2 and E3) in order to maximise Z-Axis
travel. To increase travel slide limits switches to the right, to decrease
travel slide the switches to the left
E3 (x1)
E2 (x1)
35mm
1.4”
49
Summary of Contents for ARCMILL
