EK-WL8-HS/AU
WIRELESS HEAT DETECTOR
WITH BUILD-IN SOUNDER
STFV.425238.038-AU-UM rev. 18
20.08.2020
Page
3
from
8
PROGRAMMING
The “Prog.” button on the device is used for initializing the device in the system.
Please refer to the translator manual for full instructions on how to add a child
device to the system. The device can also be initialized using the “Streletz-
Wizard
” software.
INSTALLATION
In order to install the device on the ceiling, you
need to mount the base and then screw the
device into it.
Preferably, the device should be installed at a
certain distance from metallic objects, doors, and
power
lines,
as
they
can
cause
the
communication distance to drop. It is also
important to avoid installing the device near
electronics and computer equipment in order to
protect it from potential electromagnetic interference.
INDICATION
The device has an LED which indicates its state according to the following rules.
LED indication
Device’s state
No indication or rare green flashes
Standby mode
Yellow flashes every 4 seconds
Fault state
– low battery or thermal sensor
fault
Red flashes every 2 seconds
Fire alarm
Frequent red flickering
Siren is activated
