Installing Extender Bar
Hereʼs another accessory youʼll find
useful from time to time. The extender
bar will allow you to set its sliding stop
up to 16" beyond the end of either the
infeed or outfeed fence. Fig. 8 shows
the proper placement for the extender
bar. Insert the extender bar with the
scale facing forward and lock in place
with the
1
⁄
4
-20 X
3
⁄
8
" socket head
cap screw, stainless steel washer, and
rectangular nut as shown.
A second stop extender bar can be
purchased should you want to
increase the stop range beyond both
ends of your fence.
Extender Bar and Stop
Position the extender bar about 2"
beyond the fence end and using the
supplied
1
⁄
4
"-20 X
1
⁄
2
" nylon
thumbscrew, attach the extender bar
stop. See Fig 9. The stop can be
used on either end of the extender bar
to increase your stop range beyond
the ends of the fence. When not is
use, the stop can be turned around
and locked to the extender bar. This
storage position places the stop out of
the way, leaving the front face of the
fence uninterrupted for through cut
operations.
CAUTION: Never allow the
opposite end of the extender bar
to protrude into the cut area.
Incra Stop Assembly
Using the (2) 8-32 x
3
/
8
" phillips
pan head screws and 8-32 hex
nuts, fasten the 4" long blue
INCRA rack to the INCRA Stop
and tighten the screws. Slide the
3
/
4
" x 5" plastic strip into the slot
in the stop and secure with two
1
/
4
"-20 x
1
/
2
" nylon thumbscrews.
Thread the (2)
3
/
8
"-16 x
1
/
2
" nylon
thumbscrews into the INCRA
Stop. Fig.10. One or both of
these thumbscrews can be used
to clamp the INCRA Stop to the
fence. In use, the plastic strip
provides a non-metallic stop
surface which can be shaped for
special stop setups and can be
micro adjusted by loosening the
smaller thumbscrews.
6
Fig. 9
Attach extender bar stop
Fig. 10
Assemble INCRA Stop
#8 – 32 x
3
/
8
" phillips pan
head screws
1
/
4
– 20 x
1
/
2
"
nylon thumbscrews
3
/
8
– 16 x
1
/
2
"
nylon
thumbscrews
Plastic stop strip
INCRA rack
#8 – 32 hex nut
Fig. 8
Extender bar installation
1
/
4
– 20 x
3
/
8
"
socket head cap screw
Rectangular
nut
Stainless
steel washer
1
/
4
– 20 x
1
/
2
"
nylon thumbscrew
Extender bar stop
