Big Buck Hunter™
Page 11
Version 01/05
© Copyright 2004-2005 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
PCB and Hard Drive Installation
The hard drive is shipped with a mounting bracket already attached. The bracket allows installation with a minimal number
of steps and protects the electronics from damage due to improper handling. DO NOT REMOVE the bracket, as it may
cause damage to the hard drive. Use the diagram shown below for positioning the hard drive assembly in different types
of cabinets. Make sure to position the game board and the drive close enough for the two supplied cables to reach.
A data cable is supplied for the hard drive and is required for proper operation. Test fit the cable supplied for the hard
drive before securing to the mounting surface. See the insert for installation details. The supplied ribbon cable is for data
transmission. Connect one end of this cable to the keyed connector at J21 on the game board, and the other end into the
keyed connector on the hard drive. Also connect the 4-pin connector from the ATX power supply to the hard drive.
CAUTION!
Hard drives are sensitive to both physical and electrical shock. DO NOT DROP OR KNOCK OVER the hard drive.
Avoid shocks and other electrical discharges. DO NOT REMOVE the mounting bracket from the hard drive.
Removal may cause damage to the hard drive and will void the warranty. Keep the supplied padded box for
shipping any returns. Failure to use the supplied shipping box will void the warranty.
Installation in Lower Cabinet
1. Install the CPU Board on the inside wall of the cabinet (left or right), approximately 1 ½” above the cabinet floor.
Secure the CPU board using the ten supplied #6x3/4” hex washer head sheet metal screws.
2. Locate the Hard Drive on the cabinet floor, approximately 2” from the cabinet wall, and directly in line with the JAMMA
connector. Attach with 4 #8X ¾” wood screws (supplied).
Avoid jarring or vibrating the hard drive with power
tools during installation.
3. Connect the keyed Hard Drive ribbon cable to J21 on the CPU board.
4. connect the 4-pin connector from the ATX power supply to the hard drive.
Returns
In kit games, the hard drive is shipped in a special padded box. In a dedicated cabinet, the shipping box is fastened to the
inside bottom of the cabinet. Be sure to keep this box, in case you need to ship the hard drive. Ship the bracket with the
hard drive. Do not remove the bracket from the hard drive. Failure to use the supplied box, or removal of the bracket, will
VOID THE WARRANTY
on the hard drive.
RED BOARD
PCB
Hard Drive
ATX Power
Supply
J5
J22
J21
