10
10
N E X U S | E Q U I P M E N T O P E R AT I O N S G U I D E - V 1 . 5
INSTALLATION
|
GIMBAL PROTECTION AND ATS
Attaching the Nexus i2 Automatic
Triggering Device (ATS) and
Gimbal Protection Kit
(ONE-TIME INSTALL):
The Nexus i2 ATS is attached to the bottom of the aircraft.
Once the gimbal protection kit is installed, you can install the ATS.
1) Remove the ATS Housing and gimbal protection set from the case. For
ease of installation, place the aircraft in travel mode so that the arms are
parallel with the ground plane. Flip the aircraft over gently and rest the
aircraft on the propeller mounts so that the aircraft nose is pointed away
from you.
2) Place the buckle fixing base, to the raised part in the gimbal vibration
absorbing board’s mounting slot and ensure that it is locked firmly.
3) Tighten the two screws of the cable buckle with a T8 screwdriver and
ensure that the buckle is placed firmly to the buckle’s fixing base and tighten
in place.
4) Unscrew the four (4) M2.5 screws shown. These screws will not be used
for the installation of the ATS, but should be saved in case the Nexus PRS is
removed from the aircraft.
5) Place the ATS Housing on the bottom of the Inspire 2 so that the four (4)
screw holes align and the directional arrow on the ATS housing points in the
direction of the front of the aircraft. **The Flight termination System (FTS)
should be on your right side (aircraft left) and the wiring harness (USB Cable)
should be on your left side (aircraft right).
1
2
3
4
Summary of Contents for Nexus i2 PRS
Page 16: ...16 16 NEXUS EQUIPMENT OPERATIONS GUIDE V1 5...
Page 30: ...I N D E M N I S C O M...
