12
12
N E X U S | E Q U I P M E N T O P E R AT I O N S G U I D E - V 1 . 5
INSTALLATION
|
FLIGHT TERMINATION SYSTEM
1) Remove the DJI Inspire 2 nose cap by unscrewing the four (4) nose cap
screws using the 2.5 mm hex bit included with the hardware bag.
*Do not
misplace these screws, as they will be reused when reattaching the nose cap.
2) Locate the 8-Pin and 9-Pin ESC control wire bundles at the aircraft front.
3) Squeeze the GH connector tabs and lightly pull away from the aircraft to
unplug both of these wiring harnesses.
4) The FTS is loosely hanging from the ATS housing on the left side of
the aircraft.
5) Plug the two (2) connectors from the Inspire 2, into the FTS. You’ll notice
that one of these connectors is an 8 pin while the other one is 9 pin, you cannot
reverse them.
6) Take the 8-pin and 9-pin wiring harness from the FTS and plug them into the
8-pin and 9-pin aircraft ports, respectively.
Installing the Nexus i2 Flight Termination
System (FTS)
(ONE-TIME INSTALL):
Now that you have installed the Gimbal Protection Set and the ATS on the
bottom of the Inspire 2, it is time to install the Flight
Termination System.
1
2
4
5
6
Summary of Contents for Nexus i2 PRS
Page 16: ...16 16 NEXUS EQUIPMENT OPERATIONS GUIDE V1 5...
Page 30: ...I N D E M N I S C O M...
