GB
5
Start-up and use
Starting the appliance
!
Before starting the appliance, follow the installation
instructions
(
see Installation).
!
Before connecting the appliance, clean the
compartments and accessories well with lukewarm
water and bicarbonate.
1. Insert the plug into the socket and ensure that the
internal light illuminates.
2. Turn the TEMPERATURE ADJUSTMENT knob to an
average value. After a few hours you will be able to
put food in the refrigerator.
Setting the temperature
The temperature inside the refrigerator compartment
automatically adjusts itself according to the position of
the thermostat knob.
= warmest
= coldest
We recommend, however, a medium position.
The cooling section of the refrigerator is located inside
the back wall of the refrigerator compartment for
increased space and improved aesthetics. During
operation, the back wall will be covered in frost or water
droplets depending on whether the compressor is
operating or paused. Do not worry, the refrigerator is
functioning normally.
Chiller system
The appliance comes with one of the chiller systems
described below: take note of your system in order to
determine the most efficient food storage method.
Aircooler
A
B
It is recognizable due to the presence of the mechanism
on the top part of the refrigerator compartment (
see
diagram). The Aircooler maintains a constant fridge
)RRG
$UUDQJHPHQWLQVLGHWKH
UHIULJHUDWRU
Fresh fish and meat
Above the fruit and vegetable
bins
Fresh cheese
Above the fruit and vegetable
bins
Cooked food
On any shelf
Salami, bread loaf,
chocolate
On any shelf
Fruit and vegetables
In the fruit and vegetable bins
Eggs
On the shelf provided
Butter and margarine On the shelf provided
Bottles, drinks, milk
On the shelf provided
temperature to keep food fresher for longer and will
quickly restore the temperature to the correct level, even
if the door is opened frequently: the blown air (A) is
cooled when it comes into contact with the cold wall,
whereas the hotter air (B) is sucked up (
see diagram).
The back wall may be covered in frost or droplets of
water, depending on whether the compressor is in
operation or whether it is paused.
Static
Models without the Aircooler have the cooling section in
the internal back wall of the compartments. The wall will
be covered in frost or water droplets depending on
whether the compressor is operating or paused: both
cases are normal. If the TEMPERATURE ADJUSTMENT
knob has been set on high values with large quantities
of food and with a high ambient temperature, the
appliance can operate continuously, resulting in
excessive frost formation and excessive energy
consumption: compensate for this by shifting the knob
towards lower values (defrosting will occur
automatically).
In static appliances, the air circulates in a natural way:
the colder air tends to move downwards as it is heavier.
The food should be stored as follows:
