Indesit IN TSZ 1610 UK, Operating Instructions Manual

2

GB

Installation

!

Before placing your new appliance into operation

please read these operating instructions carefully. They

contain important information for safe use, for installation

and for care of the appliance.

!

Please keep these operating instructions for future

reference. Pass them on to possible new owners of the

appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free

room.

2. Do not obstruct the rear fan grills. The compressor

and condenser give off heat and require good

ventilation to operate correctly and save energy.

3. Ensure the appliance is away from any sources of

heat (direct sunlight, electric stove, etc.).

Electrical connections

After the appliance has been transported, carefully

place it vertically and wait at least 3 hours before

connecting it to the electricity mains. Before inserting

the plug into the electrical socket ensure the following:

• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of the

appliance, which is indicated on the data plate located

on the bottom left side of the fridge (e.g. 150 W).

• The voltage must be in the range between the values

indicated on the data plate located on the bottom left

side (e.g. 220-240V).

• The socket is compatible with the plug of the appliance.

If the socket is incompatible with the plug, ask an

authorised technician to replace it (

see Assistance

).

Do not use extension cords or multiple sockets.

!

Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

!

The cable must not be bent or compressed.

!

The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

!

The manufacturer declines any liability should

these safety measures not be observed.

WARNING:

THIS APPLIANCE MUST BE EARTHED.

Replacing fuse covers:

When replacing a faulty fuse, a 13amp ASTA approved

fuse to BS 1362 should always be used and the fuse

cover re-fitted.

If the fuse cover is lost, the plug must not be used until

a replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the

correct colour as indicated by the coloured marking or the

colour that is embossed in words on the base of the plug.

Changing the plug:

Removing the plug

If your appliance has a non-rewireable moulded plug

and you should wish to remove it to add a longer cable

or to re-route the mains cable through partitions, units

etc. please ensure that either:

-

The plug is replaced by a fused 13amp re-

wireable plug bearing the BSI mark of

approval.

or

-

The mains cable is wired directly into a

13amp cable outlet, controlled by a

switch (in compliance with BS 5733)

which is accessible without moving the

appliance.

Disposing of the plug

Cut off and dispose of the supplied plug if it does not fit

your socket. The cable should be cut as close as

possible to the moulded plug.

Remove the fuse.

WARNING:

To avoid a shock hazard do not insert the discarded

plug into a socket anywhere else.