8
GB
Cleaning the condenser unit
Periodically (every month) remove the condenser unit
and clean any build up of fluff from between the plates
by rinsing it under the tap with cold water.
This should be done with cold water from the rear of
the condenser.
Removing the condenser:
1. Unplug the dryer and open the door.
2. Pull open the condenser cover (
see diagram
).
Release the three catches by turning 90˚ counter-
clockwise then pull on the grip and remove from
the dryer.
3. Clean the surface of the seals and replace, making
sure that the catches have been secured.
Cleaning the dryer
●
External parts in metal or plastic and rubber parts
can be cleaned with a damp cloth.
●
Periodically (every 6 months) vacuum the front air
intake grille and vents at the rear of the dryer, to
remove any build up of fluff, lint or dust. Also to
remove accumulation of fluff from the front of the
condenser and filter areas, clean occassionally with
a vacuum cleaner.
!
Do not use solvents or abrasives.
!
Your dryer uses special bearing components which
do not need lubrication.
!
Have your dryer checked regularly by authorised
technicians to ensure electrical and mechanical safety
(
see Service
).
Switching off the electricity
!
Unplug your dryer when not using it, when cleaning
it and during all maintenance operations.
Clean the filter after each cycle
The filter is an important part of your dryer:
it accumulates lint and fluff that is formed while drying.
When finished drying, clean the filter by rinsing it
under running water or with your vacuum cleaner.
Should the filter become clogged up, the airflow inside
the dryer will be seriously compromised: drying times
lengthen and you will consume more energy. It may
also damage your dryer.
The filter is found in front of the dryer trim (
see diagram
).
Removing the filter:
1. Pull the plastic grip of the filter upwards (
see diagram
).
2. Clean the filter and replace it correctly.
Ensure the filter is fully located flush into the tumble
dryer trim.
!
Do not use the dryer without replacing the filter.
Empty the water container after each
cycle
Pull the container out of the dryer and empty it into a
sink or other suitable drain.
Replace the water container securely.
Check the drum after each cycle
Turn the drum manually in order to remove small items
(handkerchiefs) that could have been left behind.
Maintenance and Care
Water container
Handle
Condenser cover
Catches
Air intake
Filter
Tap
Rear
Front
Condenser unit
Summary of Contents for IS70C
Page 71: ...71 A ...
Page 75: ...75 A 7 40 30 55 40 70 55 50 40 70 50 60 40 75 55 90 70 80 70 90 80 120 95 140 120 ...
Page 76: ...76 A 7 15 ...
