10
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24
press the + and – freezer temperature adjustment buttons once.
Press these buttons a second time to display the set value on the
freezer display, switch off the TEMPERATURE ALARM LED and
restore normal operation.
The alarm sounds and temperature alarm flashes on the
display (“A2” is displayed instead of the FREEZER
temperature).
• The temperature of the freezer is dangerously high: the food inside
must not be eaten. The freezer will maintain a temperature of
approximately -18°C.
To switch off the buzzer, open and close the appliance door or
press the + and – freezer temperature adjustment buttons once.
Press these buttons a second time to display the set value on the
freezer display, switch off the TEMPERATURE ALARM LED and
restore normal operation.
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The temperature that has been set is too high (
see Start-up and
use
).
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The temperature that has been set is too low (
see Start-up and
use
).
The motor runs continuously.
• The SUPER FREEZE button has been pressed (rapid freezing):
the yellow SUPER FREEZE light is on or flashing (
see Description
).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface (
see
Installation
)
.
• The appliance has been installed between cabinets that vibrate
and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
Early ending of functions
• Electrical disturbance on the network or brief interruptions of the
power supply.
Don’t forget should our advice fail to resolve the problem with
your appliance please call us on 08448 224 224 to arrange an
engineer visit. Or visit www.indesitservice.co.uk
Product failures are fully covered by your 12 months parts and
labour guarantee. However, if we attend and there is no
product failure or the failure has been caused by damage,
misuse or by incorrect installation, charges will apply.
