18 of 33
Service Manual UK
Indesit
Company
English
For selecting a new Power Limit:
•
With the (+) and (-) keys, the Power Limit is increased.
The selectable powers are: 2800W, 3500W, 6000W or 7200W. When the power is 7200W, if the
[+] or [-] key is touched the power changes to 2800W.
The sequence to finish recording the new Cooktop Power Limit is:
•
Press at the same time the left and right end heaters [+] and [-] keys.
•
Once this is done, new Cooktop Power Limit is recorded and there is a system reset.
To finish without recording changes:
•
If during 60 seconds there is no action, changes are not recorded and there is a system reset.
Switching on the Cooking Zones
Each cooking zone is switched on and controlled using the (-) and (+) POWER buttons, which at the
same time are used for power adjustment.
To begin operating a cooking zone, set the desired power level (between 0 and 9) using the (-) and (+)
POWER buttons.
Press and hold the (-) POWER button to set the power level immediately at '9'. Press and hold (+) and
(-) POWER buttons simultaneously to return to power level '0'. If the power level is '0' press and hold
the (+) button to increase the power level quickly.
Fast Boil - Booster Function
The booster function for some of the cooking zones may be used to shorten heating-up times.
It may be activated by pressing the (+) POWER button over level 9. This function boosts the power to
1600 W or 2000 W, depending on the size of the relevant cooking zone.
The activation of the booster is signalled by a beep sound, and the letter 'P' appearing on the display
corresponding to the selected cooking zone. The booster works for a maximum of 10 minutes.
After these 10 minutes a beep sounds and the cooking zone will return to level '9'.
With the heater at Booster level, if the [+] key is touched an error beep sounds and the cookset doesn’t
change. With the heater at Booster level, if the [-] key is Touched a beep sounds and the cookset is
reduced to 9.
Switching off the Cooking Zones
To switch off a cooking zone touch (-) and (+) POWER selection buttons simultaneously.
A beep sounds and the corresponding display shows '0'.
