13
Instructions for installation and use
Your safety and that of
your family
Important for the safe use of your washer-dryer
Your washer-dryer has been built in compliance
with the strictest international safety regulations.
To protect you and all your family.
Read these instructions and all
the information in this manual
carefully: they are an important
source, not only of numerous
useful tips, but also of vital
information on safety, use and
maintenance.
1. the machine should not be
installed in an outdoor
environment,
not even
when a roof shelters the
area, because it may be very
dangerous to leave it
exposed to rain and
thunderstorms.
2. It must only be used by
adults
and exclusively for
washing clothes following
the instructions provided in
this manual.
3.
Should it have to be moved,
proceed with the help of two
or three people and handle
it with the utmost care.
Never try to do this alone,
because
the appliance is
very heavy
.
4.
Before loading the washer-
dryer,
make sure the drum
is empty.
5. Never touch the washer-
dryer when barefoot
or
with wet or damp hands
or feet.
6. Never use extensions or
multiple plugs
, which are
particularly dangerous in
humid environments. The
power supply cable must
never be bent or
dangerously compressed.
7. Never open the detergent
dispenser while the
appliance is functioning;
do not use hand wash
detergent
because the
abundance of foam could
damage its internal parts.
8. Never pull on the supply
cable
or the washer-dryer to
disconnect it from the wall
socket: it is extremely
dangerous.
9.
While the appliance is
functioning,
do not touch
the drain water
as it could
reach very high tempera-
tures.
The appliance door,
during wash cycles, tends
to become hot; ensure
that children do no touch
it.
Never force the washer-
dryer door
because this
could damage the safety
lock which prevents
accidental opening when the
nachine is working. Allow a
few minutes at the end of the
program for the lock to
release.
10. In case of malfunctioning,
first close the water tap
and unplug the appliance
from the wall socket;
do
not under any circum-
stances touch internal parts
in order to attempt repairs.
I only want an authorised
specialised technician with
original Indesit spare parts!
How to change the power supply cable
The washer-dryer power
supply cable is special and
can be purchased exclusively
from authorised Technical
Service Centres.
To replace the cable:
1.
Make sure that the machine
is switched off and unplugged.
2.
Remove the covering lid by
unscrewing the two screws
I
, and
then pull it towards you [fig. 3].
3.
Disconnect the wires from
the radio interference
suppressor
F
[fig. 4] noting as
to their position (
Blue=N
wire;
Brown=L
wire) leaving the
earth wire until last
.
N.B.:
letters
L
,
N
and the
symbol
are indicated on the
radio interference suppressor.
4.
Remove the upper part of the
cable slightly from the back
panel of the appliance, pull the
power supply cable upwards and
take it out [fig. 5].
To connect the new power
supply cable, reverse the pro-
cedure.
To put the covering lid back on,
rest it on the washer-dryer
[fig. 6] and let it slide forwards
until the hooks situated on the
front slide into the special slots
formed into the control panel
and tighten the screws back on.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
I
N
L
F
Summary of Contents for WD 84 T
Page 3: ......
