I
L
A
B
C
H
D
F
G
E
The washer-dryer is equipped
with an extra compartment
4
(provided as an accessory) for
the bleach, to be inserted in
compartment
1
.
Slow spin
Use this button to reduce the
spinning speed from 800 to 400
rpm for the cotton and linen
programmes and from 700 to
400 rpm for the synthetic
fabrics programmes.
Rapid wash
This button reduces the length
of the wash programme by
about 30%. It cannot be used
with special programmes (see
page 4) or those for wool and
silk.
Stain removal (see page 8)
Thanks to this command, the
washer-dryer will carry out a
more intensive wash that
optimises the effectiveness of the
liquid additives, thus allowing
more resistant stains to be
removed. When you press the
stain removal button, you cannot
activate the pre-wash.
On-off
When button
H
is pressed, the
washer-dryer is switched on,
when it is not the machine is
switched off.
Turning the appliance off
does not cancel the selected
programme.
Here I’m in command
Understanding the control panel
Making the right choice is important. And it’s easy.
Programme selector knob
Use this knob to select the wash
programme.
Turn this knob clockwise only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the knob.
Now press on/off button
H
(position
I
), pilot lamp
I
will start
flashing.
After 5", the setting will be
accepted, pilot lamp
I
will stop
flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols
(Stop/Reset) and wait
5" : when the cancellation has
been accepted, pilot lamp
I
flashes, and you can then turn the
appliance off.
After the wash cycle has been set
and accepted by the washer-
dryer, turning the knob will have
no effect (except for when it is on
position Stop/Reset).
Temperature control knob
It is used to set the wash tempe-
rature in the recommended
programme table on pag. 4. It also
allows you to reduce the tempe-
rature recommended for the
selected programme, and even
to set a cold wash cycle (
).
Drying cycle knob
Use this knob to select the
desired dr ying cycle. Two
options are available:
A
- Based on time:
From
40
minutes to
150
.
B
- Based on the damp level of
the dry clothes:
Iron
:slightly damp clothes,
easy to iron.
Wardrobe
: dry clothes to
put away.
Extra dry
: very dry clothes,
recommended for towelling and
bathrobes.
A cooling stage is foreseen at
the end of the drying cycle.
Detergent dispenser
It is divided into 3 compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
3
Instructions for installation and use
On-off lamp / door locked
Lamp
I
flashes slowly when the
appliance is switched on and
awaiting instructions and at the
end of a cycle, indicating that the
door can be opened. It flashes
quickly when the door should
not be opened. A steady light
means the appliance has
accepted the selected
programme.
Drying cycle lamp
When this lamp is on, it means
that knob
C
has been set on a
drying cycle and at the end of the
wash cycle, the appliance will run
the selected tumble drying cycle.
Anti-crease
This function (represented by the
symbol
) interrupts the wash
programme, keeping the washing
soaking in water before draining.
It is only enabled in programmes
for synthetic fabrics, silk and
cur tains. It is ver y useful,
because it prevents delicate and
synthetic fabrics from creasing
(for example, when you cannot
take the washing out at the end
of the wash cycle but only a few
hours later). The programme can
be completed by turning knob
A
one notch. In the case of
synthetic fabrics
, should you
prefer
draining
rather than a
spin
cycle
, turn knob
A
until you have
selected the symbol
(
Drain
).
The detergent dispenser with the
additional bleach compartment
is here.
1
2
3
4
Summary of Contents for WD 84 T
Page 3: ......
