Index Braille Printer Company
Manual Index Everest-D
Version 4.32
Page 4
1.
Unpacking.
1.1
Unpacking instructions.
1. Open the top of the box, and remove the chock absorbing plastic.
2. Lift the Everest-D from the box and place it on a table.
3. Check that the voltage on the printer is the same as your voltage, 115 or 230V.
Note!
If the pre-installed voltage by any reason should be incorrect, change the voltage on the
switch under the left leg.
4. Save the transportation material back in the box.
5. Place the document collector underneath the printer.
6. Pull out the two plastic printinghead transportation lockings, located in the sheetfeeder. Save
them together with the transportation material in the box. It is important that you replace
them if you by any reason need to ship the printer.
Note!
Printer should be shipped only in original packing!
7. Put both paper guides on the top of the sheet feeder.
We understand that you want to test your Everest, however we recommend that you read
chapters 1-3 in the manual before you start to use your printer.
Before installing the printer make sure that there is no visible damages to the printer and that the
delivery is complete. If you encounter any problems, contact your local dealer.