System1000_GB_130705.doc
Page
14
21.3 Checking the Function
Place the door contact and the magnet so that the
arrows are facing towards each other. Arm the
system by pressing the ON button on the keyfob. The
siren bleeps once, and the LED flashes. After ten
seconds, the siren bleeps once again. Now the system
is armed. Pull the magnet away from the door
contact. The LED is green, and the siren should
trigger an alarm after an entry delay of ten seconds.
If the siren does not sound, check the battery and the
code. To silence the alarm and to disarm the system,
press the OFF button on the keyfob. Before installing
the door contact, also check the function in the
position where you want to install it.
21.4 Installation
The magnet is fixed to the door or window and the door contact to the door- or window frame (or vice
versa; this does not affect the function of the door contact). The parts can be installed on the right or left
side of a door or window; this does not affect the function either.
Advice: Installing the door contact on the bottom side of a window allows you to open the window at
the top without an alarm being triggered.
The two arrows can help you to bring the magnet and the door contact into line. The distance between
magnet and door contact should not exceed 5 mm.
fig. 23
fig. 22
fig. 24
