26 - GB
Indexa GmbH
Paul-Böhringer-Str. 3,
74229 Oedheim
Germany
www.indexa.de
Fault
Message“NO SIGNAL”
Unstable wireless reception
Interference in picture
Source device does not react to infrared remote
control
Remedy
Check the power supply to the devices
Check all connections of the A/V cables
Reduce the distance between transmitter and receiver
Remove large objects, in particular metallic objects or change the
location of transmitter and/or receiver
Adjust the orientation of the antennae to get the optimal wireless
connection
Reduce the distance between transmitter and receiver
Remove objects, in particular metallic objects and/or change the location
of transmitter and/or receiver
Check that there are no interference sources near transmitter and receiver
eg WiFi device, electrical products, Microwave ovens
Ensure a minimum distance of 2 m between transmitter and receiver
Aim the infrared transmitter widow of the transmitter DF-120TX at the
infrared window of the source device
When using an infrared remote control aim it at the infrared receiver
DF-120RX window of the receiver
See chapter 10.1
Cause
Transmitter or source device not powered
A/V cables not connected
The transmitter is out of range
Objects are preventing wireless connection
Antennae are not in the optimal orientation to each other
Receiver and camera too far apart
Wireless connection is blocked
Interference with wireless signal
Transmitter and receiver are too close to each other
Infrared transmitter window is not aimed at the infrared window of
the source device
Infrared remote control is not aimed at the infrared receiver
window of the receiever
“Pairing has not been carried out or has been lost
17. Trouble shooting
