P/N 9925955 Rev 02 04/15 Page 4 of 9
14. Disconnect the fuel pump wire harness (H).
H
15. Remove the two socket head screws (J) from base
of fuel tank (using 6 mm hex key).
16. Remove the fuel tank by carefully lifting up the
base while sliding the tank towards the rear of the
vehicle.
17. Remove the wire tray cover (K) by cutting the zip
tie at the base, and prying up the cover from one
side.
NOTE: Note how the zip tie is routed at the base
for later assembly.
NOTE: Though not necessary, it may be easier
to route the wires if the VCM / battery cover is
moved out of the way. To do this, remove the M6
fastener that holds the battery cover in place. Lift
battery cover with VCM attached and tip forward.
CAUTION: Care must be taken to not allow the
VCM to contact the battery terminals. Also, no
metal must be allowed to touch both the terminal
and VCM at the same time (such as wrenches,
etc.). Contact with terminals will damage the
VCM.
J
K
