P/N 9925955 Rev 02 04/15 Page 5 of 9
18. Remove chrome trim – remove two upper fasteners (L) using the 4 mm hex socket. The trim piece is
now held on by a hook on the bottom and darts and grommets on the top. Pull forward on the top of the
trim to disengage the darts, then lift the bezel (M) up and out of fairing. Torque the fastners to 36 in-lbs.
(4.07 Nm). See Figure.
19. Remove headlight and unplug - using 10 mm socket, remove the three fasteners (N) holding the
headlight in place. Unplug wire harness from back of light, and carefully set headlight assembly to the
side. Torque the fastners to 36 in-lbs. (4.07 Nm).
20. Remove speaker covers (Q) - pull
rearward on outboard edge to
disengage darts from grommets
and then slide outboard.
NOTE:
Care should be taken
when
removing the speaker covers to
avoid scratching the dash.
21. Remove three fasteners (R) on
each side between inner and outer
fairings using 4 mm hex key socket.
See Figure.
R
Q
Q
Remove Outer Fairing
L
N
M
P
R
Q
Q
