Indu-Sol EM Check ISMZ I, User Manual

Operation

 
Intelligent current clamp meter ISMZ I – User Manual 

8 

Operation 

3

Switching on/off 

3.1

Pressing the red Power button (1) switches the ISMZ I on. When the clamp is switched on, it can be set 
into standby mode by briefly pressing the red Power button (1). Pressing it longer switches the ISMZ I off. 

Standby mode 

3.2

The standby mode is a power-saving function. All measurements remain active and are not lost. You can 
also specify in the settings how long the period of inactivity should be before the clamp automatically 
switches into standby mode. The display is deactivated in standby mode. Standby mode is indicated by 
brief flashing of the standby LED. 

Menu control 

3.3

Press the Mode button (2) to leaf through the menu of the clamp to access the settings and functions. 

The following menu pages are available: 

CURRENT   

- 

Effective value measurement (main menu) 

CURRENT COURSE  - 

Course of the current over time 

SPECTRUM  

- 

Display of frequency components 0..20 kHz 

TEACH…   - Automatic 

teaching of trigger thresholds 

REC. CONFIG 

- 

Configure recordings and trigger 

SETTINGS   

- 

Basic settings of the measuring clamp 

STATUS  

- 

Memory and battery, status of the recordings 

You can confirm entries by pressing the Enter button (8). 

Use the arrow buttons (6), (7), (9) and (10) to scroll through the menu and also to change input values 
and zoom stages. 

A recording can be started or stopped any time by pressing the Rec button (4). 

Switch the display illumination on and off by pressing the Display illumination button (3).