P. I. E. INEL Sp. z o. o., ul. Mostowa 1, 80-778 Gdańsk, inel@inel.gda.pl www.inel.gda.pl
a. Press and hold the "
↑
" button.
b. Release the button after the drive stops (if the button
is not released within 3 s the drive will enter
automatic programming mode). Fine tune the
position by short pressing the "
↑
" or "
↓
" buttons.
c.
Press and hold the "
↓
" to confirm the upper limit.
The roller blind will make a short movement, and
then confirm that the upper limit position has been
saved by two down-up sequences. It will then start
moving down. At this point release the button and
start programming the lower limit.
LOWER LIMIT
Lower limit in the desired position:
a. Press and hold the "
↓
" button.
b. Release the button in the desired lower limit position.
Fine tune the position by short pressing the "
↑
" or
"
↓
" buttons.
c. Press and hold the "
↑
" button to confirm the lower
limit. The roller blind will make a short movement,
and then confirm that the lower limit position has
been saved by three up-down sequences. It will then
start moving up until it reaches the upper limit, where
it will confirm that programming is finished.
OR
Lower limit on sill:
a. Press and hold the "
↓
" button.
b. Release the button after the drive stops on the sill.
Fine tune the position by short pressing the "
↑
" or
"
↓
" buttons.
c.
Press and hold the "
↑
" button to confirm the lower
limit. The roller blind will make a short movement,
and then confirm that the lower limit position has
been saved by three up-down sequences. It will
then start moving up until it reaches the upper limit,
where it will confirm that programming is finished.
In the semiautomatic lower limit programming phase (on sill), the
motor will attempt to detect the type of hangers used. After the
drive detects the sill, it will make another 1/4 revolution. If no
overload is detected at this point (lower RPM), it will move back
by 1/4 revolution (no blocking hangers detected). If overload is
detected during the 1/4 revolution, the motor will stop at the
position of overload (blocking hangers detected). Press the "
↑
" to
set the limit.
The service cable is fitted with two buttons and one switch:
(2-position, bistable) – applies voltage to the
'up' direction only.
(monostable) – allows for applying voltage to
the 'up' direction.
(monostable) – allows for applying voltage to
the 'down' direction.
Previously used service cable
The monostable "Program" button allows for
applying voltage to the 'up' direction.
The tristable switch allows for applying voltage to
the 'up' and 'down' directions.
Applying voltage to both directions at the same
time is possible after pressing both the
"Program"
and "Down" switch.
4.
RETURN TO FACTORY MODE
You can return from the operation mode to the factory mode
if necessary - however, this will erase the limit positions.
It can be done
with a blind switch
in following manner:
Press the buttons of the switch in the following order, making
the roller blind perform a short move each time:
↓
↓
↑
↓
↑
↑
↑
The last press will confirm the entered sequence - it should last
at least 2 seconds.
The return to the factory mode will be confirmed by a short up-
and-down movement of the roller blind.
3. SERVICE CABLE
