C-Com Satellite Systems Inc
Page 40 of 77
iNetVu™ 5000 Controller User Manual
Revision 1.0.2
Target Calibrate
Updates the Elevation, Polarization, and Compass offsets in the registry and
iNetVu™ Controller’s EPROM.
This function is automatically performed after initially finding satellite. It should
not be performed again unless the satellite has been found and locked onto.
Target Calibration is typically not required as this procedure is done prior to the
system being shipped. Only under the instruction of a certified C-Com technician
should calibration be performed again.
Enable Transmitter
Enables/Disables the Transmitter when locked onto satellite.
Deploy Antenna
Automatically moves antenna to the manually entered Elevation, Azimuth and
Polarization angles.
Fig. 27:
Deploy Antenna Input Values
Record Data
Enables and disables an “always-on” data recording process.
With iNetVu™ Mobile Software versions 4.0 and higher, parameters are
continuously recorded while the platform is searching for the satellite. It
automatically stops once the satellite is locked and confirmed. Messages are
always recorded in the Message Panel.
Data Log filename:
iNetVuData5000.txt
.
Network Test
To confirm network connectivity, iNetVu™ Mobile Software will attempt to
connect to the iNetVu™ Server via the Internet.
Point Satellite
Automatically points antenna to the manually entered Satellite Longitude, but
does not attempt to lock onto the signal, and/or enable the transmitter
automatically
Fig. 28:
Point Satellite Input Values
This function is recommended for Satellite TV subscribers for finding their
desired Satellite.
