C-COM Satellite Systems Inc.
Page 123 of 164
RF Override
Enable to use the value that is entered in the RF Threshold field, otherwise the default
real time RF value from the tuner will be used.
RF Threshold
Used by the iNetVu
®
Mobile Software to begin a signal optimization process for peaking
on a Satellite signal after initially locating it. This field should only be used if the RF
threshold is to be overridden. Ka Band systems with single TRIA cable will have the RF
threshold set to 75 by default (service dependent), this allows the RF Signal to be in
operation range (RF Signal==70 on iNetVu Controls window) thus allowing the search
process to begin. The RF Threshold can also be manually set to any value ranging from
40 to 60 which will display the true value of RF Signal on the iNetVu Controls window.
Setting the RF Threshold to 30 will put the search into a step-through-search moving the
AZ axis in small incremental steps, this method increases the search time.
8.2.3.7. Controller Feature
These features are modem dependant and different features will display depending on
the type of modem selected in the modem configuration interface.
Transmit DC Enable (iDirect only)
Allows user to disable the DC power supplied by the modem to the BUC after TX enable
is sent to modem. This allows power to be supplied by an external power source and
hence bypassing the modem. Transmit DC Enable is checked by default and by
unchecking it would disable DC supply from modem and allow the user to control DC
power supply to the BUC
.
Enable iDirect Broadcast (iDirect only)
The 7000 Series Controllers can be configured to broadcast with iDirect service. This
allows iDirect users with broadcast configured modems, to lock onto a DVB carrier, and
enable the transmitter in the iDirect modem automatically after peaking through the 7000
Series Controller. This happens when reference satellite is used and system deploys to
the target but no signal lock is achieved, the controller will than use the last position and
perform a blind search.
Motion Protection
The iNetVu
®
Mobile Platform will automatically stow the antenna should it experience
extreme motion, such as severe shaking caused by harsh weather conditions. Box
selected implies Motion Protection is enabled.
