C-COM Satellite Systems Inc.
Page 39 of 164
1 – RF Search Mode Status
N
RF Mode is disabled;
Y
will be displayed when enabled
.
N
RF override mode is disabled;
O
will be displayed when enabled.
RF Threshold (55)
Value will be displayed here, this value is configurable.
RF/DVB signal value (30N) –
If in RF search mode this will represent RF signal value, if in DVB
Mode it will display DVB carrier signal. The letter ‘
N
’ next to the
RF Value indicates the LNB is not being powered properly.
The letter “
L
” next to the value indicates a DVB signal LOCK.
2 –
CP (Compass) Status
V
Valid – The compass reading is functioning properly
O
Override – the compass has been overridden, and direction entered manually
considered
FS
Full Search – searches a full 360º search window.
3 – Compass Heading/ Calibrate/Check Compass Routine
Displays Compass Heading after Compass has been read.
Approximate Headings:
North 354
East 87
South 176
West 265
Antenna will rotate 90° to each of the following positions and read the compass
at each: 0°, 90°, 180°, -90°, 0° and display the compass headings. Vehicle front
end (windshield window) must be pointed North during these routines to achieve
proper compass headings and a software pop-up will be displayed on the pc
screen to ensure this Platform is properly orientated.
4 - AZ Search Window Status
The Search Window is the area of the sky which the iNetVu
®
Mobile System will
search for the desired Satellite. It uses a rectangular window and searches for
the Satellite using smaller concentric windows until the desired Satellite is found.
