Hardware Manual XE166 Easy Kit Board Version 3.1
Information in Detail
Hardware Manual
15
V1.2, 2009-08
3.2.2
CAN1/2 (X110, X111)
On the board are two CAN transceiver connected to the MultiCAN on XE166 node 0 and 1. The transceivers are
connected to two IDC10 plug. For the pinout of IDC10 plug see Figure 7. You can use a IDC female connector
with crimp connector, flat cable and SUB-D 9 plug with crimp connector to have a 1:1 adapter to SUB-D 9.
Figure 7
On-board header (X110,X111)
Note: If the Board is equipped with a XE162FM in a 64 Pin package the CAN2 interface is disabled. To enable
remove R238 and solder R136. In this case USIC 0 channel 0 is not available on Pin 2.4.
3.2.3
LIN Interface (X104)
The board has a connector with 4 pins for LIN. For the pinout of the connector see Figure 8. The LIN transceiver
is connected to USIC1 Channel 0 module of the CPU.
Figure 8
On-board header (X104)
3.2.4
OCDS Interface
The OCDS1 signals are connected to the IDC16 plug (X202). For pinout of the connector see Figure 9. You can
connect any debugger to this connector.
The signals /BRKIN and /BRKOUT are not connected per default. If you need this signals in the connector then
assemble R225 and R226 with a 0R resistor.
If you connect a debug hardware make sure that the MiniWiggler circuit is not active (ACTIV LED is off) and on
the DAP connector (X204) is no hardware connected or the hardware is tristate.
If the ACTIV LED is on, then stop the active DAS Server JTAG over USB Chip and/or remove the USB connection
to the PC.
2
4
6
8
1
3
5
7
9
10
GND
GND
CAN2L
CAN2H
VDDP
1
2
3
4
GN
D
Vs
Bu
s
VB
at
